Neil Pryde Trim Lock Boom adjuster.
Neil Pryde Boom Rear End Trim Lock adjuster (Supplied as a pair as they are handed) for the earlier X3-X6-X9 range and the current .
2 x Adjuster Clip and 2 x Barrels supplied.
All now in Blue, unless stated as otherwise.
Please measure your rear end tube diameter and the boom arm that the barrel fits onto (you will need to remove the barrel to do this). Remove the adjuster by carefully prizing it off. Stand the boom arm in a cup of boiling hot water to expand the barrel and soften any glue, leave for a couple of minutes and then twist off the barrel.
Five Sizes available to cover both current and older Neil Pryde Booms.
The 1st measurement is the diameter of the barrel where the boom Rear End tube enters and the 2nd is the barrel diameter to fit onto the boom arm. Do ask if you are not sure about any of this!
21mm x 25mm (these are in Orange)
23mm x 27mm
24mm x 28mm
26mm x 30mm
30mm x 35mm
Description 2 (below) . This info is from SHQ in Australia (hope you don't mind us borrowing it!) which may help but don't hold us to it!
Product tabs
- Description 2
Neil Pryde Trim Lock 21mm / 25mm
Replacement back end boom locks (Trim locks) for 140 and 160 length Neil Pryde X6 and X9 windsurfing booms
21mm diameter for the boom back end 25.2mm diameter onto the boom grip end
Sold as a pair (2 x bodies, 2 x clips)
The pin diameter is 6.3mm Pin length is 8.5mm The Pins are Centered at 20mm
Colours available: Orange
Neil Pryde Trim Lock 23mm / 27mm Wave Boom Blue
Replacement back end boom locks (Trim locks) for 140 and 160 length Neil Pryde X6 and X9 windsurfing booms
27.5mm diameter onto the grip end
23.5mm diameter for the boom back end
Sold as a pair (2 x bodies, 2 x clips)
The pin diameter is 6.3mm Pin length is 8.5mm The Pins are Centered at 20mm
Colours available: Blue
Neil Pryde Trim Lock 24mm / 28mm Wave Boom Blue
Replacement Trimlock clips for your Neil Pryde wave boom
Sold as a pair (2 x bodies, 2 x clips) for X6 / X9 140 / 160 Booms
The pin diameter is 6.3mm Pin length is 7mm The Pins are Centered at 20mm
One end of the barrel measures 23.9mm (back end sliding tube) diameter and the other end measures 28.2mm (for 28mm boom arm without EVA grip) - takes approximately 23.5mm Dia back end tube.
Only Blue is available currently in this model.
Neil Pryde Trim Lock 26mm / 30mm Boom
Replacement Trimlocks for a Neil Pryde boom
The pin diameter is 6.3mm Pin length is 6.5mm The Pins are Centered at 20mm
Sold as a pair (2 x bodies, 2 x clips)
One end of the barrel body measures 26.4mm (back end sliding tube) diameter and the other end measures 30mm to fit 29 to 30mm boom arm (without the boom grip) - so takes a 26mm back end
Colours : Blue,
Neil Pryde Trim Lock 30mm / 35mm Race Boom Blue
Replacement race locks for neil pryde carbon boom - now in blue colour
Sold as a pair (2 x bodies, 2 x clips)
30.3mm diameter where the sliding back end of the boom goes in
35.2 mm diameter going onto the boom arm
The pin diameter is 6.3mm Pin length is 9.5mm The Pins are Centered at 20mm
Colour. Blue